Heat Resistant Spray Paint for Building

Heat Resistant Spray Paint
2-3 square meters/KG/coat (two layer)
High reflectivity
High emissivity,
Low heat capacity

Heat Resistant Spray Paint for Building

Heat insulation anti-sunshine exterior paint

Package: 20KG/barrel Color: White and other colors

Application Method		Roller	Spray
Theoretical coverage :		3 to 5 square meters/KG/coat(two layer)	3 to 5 square meters/KG/coat(Two layer)

The practical consumption may vary with substrate condition, construction methods, environment and other factors.

Storage Condition: Store in cool, dry and ventilated place,away from fire.

Product Introduction:

SAILI Heat insulation flexibility exterior coating adopts advanced aerospace adiabatic technology. It can form excellent adiabatic coating with three high and one low properties: high reflectivity, high emissivity, high heat resistivity and low heat capacity, which can low the surface and inner temperatures of the substrate, and cut down by thirty percent of the electrical energy consumed by airconditioner. The energy-saving effect is obviously.

Scope of application:

Can be used for the surface of concrete floor and walls, container need to isolate the solar thermal radiation.

Theoretical consumption of paint: 3~4 Square meter/L, (two layer, 0.2~0.3mm dry film thickness the practical dosage may vary with substrate condition, construction methods and other factors.

Dilution:

No more than ten percent of water needs to be added to dilute for the sake of application convenience.

Repainting time:

Dry for more than two hours before subsequent application (25C, seventy percent of relative humidity).

Color:

White is recommended, and can be adjusted with water-based colourant if necessary.

Construction methods:

Can be used by brushing, rolling or spraying.

Construction procedure of wall:

Construct exterior wall putty for 2~3 times brush exterior wall special primer 1 time brush thermal insulation coatings 2 times acceptance checks.

Substrate requirements:

Substrate surface should be clean, dry, smooth, firm, no grease and no rust, etc., the water content of cement-based surface should not exceed 10%, and PH value should below 10.

Application conditions:

Application temperature 5~40 C, the maximum relative humidity should be less than 85%. Avoid application on windy, rainy, foggy and high air temperature weather. After coating, keep away from rain more than 3 hours.

Heat Resistant Spray Paint for Building